ZSOM-Control

The ZSOM-Control is an off-the-shelf hardware module from NI Embedded-Specialty Alliance member Schmid Elektronik, integrating the NI System-on-Module sbRIO9651 on an industrial carrier board. It is designed for embedded measurement and control applications and can be fully programmed with LabVIEW RT and LabVIEW FPGA. All necessary process I/O signals are available on two rugged clamp terminals. An optional PCIe card adds 4G, GPS or WIFI to the system.

The ZSOM-Control is available as starter kit

fact sheet
Examples (login required)
Product chnage notification Hardware revision 1.2 June 2020
Mechanical drawings

12x analog in, 16 bit, ±5V or ±10V, 450kHz simultaneous, 4th order antialiasing with fg=200kHz.
4x analog out, 16 bit, ±10V, OVP, 100kHz simultaneous generation of all 4 channels.

16x general purpose high speed I/O (DIO), configurable as digital input or output, 3.3V or 5V operation, speed in the MHz range allows to integrate high performance SPI devices. The SDK features VIs for the integration of digital busses like I2C and SPI
10x rugged digital input (DIN), 3-30V, OVP (DINX)
6x rugged open collector output (DOUT),max current: 200mA.

1x GigE Ethernet
1x USB Host/TypeA
1x USB device/TypeC
1x CAN / CANOpen ¹⁾
1x SD-Card
1x RS232 with hand shakelines
1x RS422/RS485
1x miniPCIe slot with SIM card holder for 4G Modem, Wi-Fi module GPS receiver with phantom supply etc. ²⁾

1x RGB interface for 5.7” multitouch display
1x 3.3V and 1x 5V power supply, switchable, short circuit protected, up to 300mA
1x reset button
4x status LED’s
1x 9 axes IMU

Main wide input range 10-30V power supply

The ZSOM-Control is available in a single configuration.
Previousely available configurations such as the version with display are available as add-on configuration.