Example: Mini RTC

With this example you can read and write the system time and the time of the precise real time clock on the ZSOM-Mini board. You can also set alarms in the precise RTC to wake up the ZSOM-Mini from power off mode.

Project: ZSOM-Mini_RTC.lvproj. In LabVIEW, open Help → Find Examples and search for “ZSOM”.

RT code: front panel
RT code: front panel

Section Function
RTC (ZSOM-Mini base board) Shows the current time of the RTC (time) and writes a new time (time to set RTC). Alarm 1 and alarm 2 can be set with the alarm type, for example Alarm once per second.
status Shows whether alarm 1 and alarm 2 are enabled, the alarm flags and whether the time is valid
settings Enables the alarms and resets the valid flag and the alarm flags
System Time (sbRIO9651) Shows the system time of the target, its time zone and writes a new system time
GPIOs The GPIOs that control the power distribution, see Example: Mini GPIO
  • FPGA (RTC_FPGA_main.vi): Implements the TWI bus to the RTC on the base board and provides the GPIOs. The RT exchanges the data with the bus through FIFOs.
  • RT (RTC_RT_main.vi): Loads and starts the FPGA and runs three parallel loops (wait time 500 ms): System Time, RTC (read the current time, write the time, write alarm 1, set the control register) and GPIOs. The writing actions are started with the buttons write.

RT code: block diagram
RT code: block diagram

  • Last modified: 4 weeks ago