Reset

The reset can be applied with the on board reset button and by pulling the reset input low, depending on the target's capabilities.

While reset is held, the Status LED is off for up to five seconds. After reset, it stays on until the operating system on the sbRIO-9651 has loaded.

To reset the network settings follow the following steps:

1. Power the device
   1. Wait until the STATUS_LED gets dark.
   2. The device is in Run Mode
2. Press and hold the reset button
   1. Wait until the STATUS_LED gets dark again
3. Release the reset button
   1. Wait until the STATUS_LED gets dark again
   2. The device is in Safe mode
4. Press and hold the reset button
   1. Wait until the STATUS_LED gets dark again
5. Release the reset button
   1. Wait until the STATUS_LED gets dark again
   2. The device is in Safe mode with reset network settings