ZSOM-Control

The ZSOM-Control is an off-the-shelf hardware module from NI Embedded-Specialty Alliance member Schmid Elektronik, integrating the NI System-on-Module sbRIO9651 on an industrial carrier board. It is designed for embedded measurement and control applications and can be fully programmed with LabVIEW RT and LabVIEW FPGA. All necessary process I/O signals are available on two rugged screw terminal blocks. An optional miniPCIe card adds 4G, GPS or Wi-Fi to the system.

The ZSOM-Control is also available as a starter kit.

ZSOM-Control

ZSOM-Control

Previous Next

• fact sheet
• Examples (login required)
• Product change notification Hardware revision 1.2 June 2020
• Mechanical drawings

• 12x analog in, 16 bit, ±5V or ±10V, 450kHz simultaneous, 4th order antialiasing with fg=200kHz.
• 4x analog out, 16 bit, ±10V, OVP, 100kHz simultaneous generation of all 4 channels.

• 16x general purpose high speed I/O (DIO), configurable as digital input or output, 3.3V or 5V operation, speed in the MHz range allows to integrate high performance SPI devices. The SDK features VIs for the integration of digital busses like I2C and SPI
• 10x rugged digital input (DIN), 0–30V (high level > 2.5V), OVP (DINX)
• 6x rugged open collector output (DOUT), max current: 150mA.

• 1x GigE Ethernet
• 1x USB Host/TypeA
• 1x USB device/TypeC
• 1x CAN / CANopen
• 1x SD-Card
• 1x RS232 with handshake lines
• 1x RS422/RS485
• 1x miniPCIe slot with SIM card holder for 4G modem, Wi-Fi module or GPS receiver with phantom supply etc.

• 1x RGB interface for 5.7” multitouch display
• 1x 3.3V and 1x 5V power supply, switchable, short circuit protected, up to 300mA
• 1x reset button
• 4x status LEDs
• 1x 9-axis IMU

Main wide input range 9–28 V power supply

• Pinout

The ZSOM-Control is available in a single configuration.
Configurations offered previously, such as the version with display, are now built from ZSOM-Control plus add-ons (e.g. ZSOM-Display-ETV570G2DHU).

Previously available Versions:
ZSOM-Control-ST-00-SE: Standard screw terminal version without display.
This article is now ZSOM-Control.

ZSOM-Control-ST-DV-SE: Standard screw terminal version with display.
This article is now ZSOM-Control + ZSOM-Display-ETV570G2DHU